Vinker MG-B Home Anti-theft Door and Window Motion Sensor magnetism + vibration Two in one Anti-Burglar Security Alarm System with Remote Control Motion Detector [並行輸入品]

商品説明

Specification
1. Door Contact uses three AAA(7#) batteries(not included)
2. Remote control uses one 12V/27A battery(included)

Please use alkaline battery to get using effect. if other batteries are used,it may head to the using time of the battery to become shorter or alarm sound to become weak.

Installation
1. Choose the location of a door or window to install the alarm. Clear the installation surface with clear water and a piece of wiper. Stick the double-side adhesive at the alarm and then stick the alarm. use the place you have cleared.
2. After installing the alarm. use the double side adhesive tape to stick a magnet box on the door or the frame on the door near the alarm, Please notice that arrow head of the magnet box should point at that of the alarm on the night.

Note
● The alarm should be used indoor only. Don't install it at the place where there is sunshine or rain. Don't install it at the area where it is highly polluted or wet.
● The magnetic sensor is at the right side of the host, so the magnet box should be installed on the right side of the host and makes sure the arrow point at each other.
● If the alarm is installed on the door, please Install the magnet box on the frame of the door. If you install the alarm on the frame of the door,then install the magnet box on the door. Make sure that when the door is opened, the magnet box should be separated from the alarm, so that it can detect and trigger alarm
● When installing, make sure the distance between the alarm and the magnet box should not be more than 10mm it the door is closed.

Battery low indicate
1. When the alarm battery goes low, the LED will flash once every second. Pease replace the battery.
2. When the LED of the remote control turns dark or the control distance becomes short, please replace the battery.